Come trasformare un joystick in USB?

by

To connect a PlayStation controller to your PC, you will need the following:

  • A PlayStation 2 controller
  • A USB dongle

Once you have these, follow these steps:

  1. Connect the USB dongle to your PC.
  2. Turn on the PlayStation controller.
  3. Connect the Sony controller’s communication port to the smaller connector of the USB cable.
  4. Connect the other end of the cable to a USB port on your computer.

To connect a PlayStation 3 controller to your PC, follow these steps:

  1. Turn on the controller.
  2. Connect the Sony controller’s communication port to the smaller connector of the USB cable.
  3. Connect the other end of the cable to a USB port on your computer.

To connect a Bluetooth controller, follow these steps:

  1. Set up the Bluetooth controller.
  2. In the Android device settings, select the option to enable Bluetooth connection.
  3. Select the desired controller.

If the joystick doesn’t work, try the following solutions:

  • Resetting the controller: There is a small reset button near the L2 button on the back of the Dualshock 4 controller. Press and hold it for a few seconds with a toothpick or needle.
  • Last resort: Try holding down the PS button for 10-15 seconds.

If the DualShock 4 controller continues to blink or refuses to turn on, it may be due to a battery or power issue. Try the following steps:

  1. Connect the controller to a power source for at least thirty minutes or two hours if it hasn’t been used for a long time or if it was completely discharged.

If a PS4 controller doesn’t work properly due to a firmware issue, you will need to reset the controller. Press the small hardware reset button to do this.

To reset a joystick:

  1. Locate the reset button near the L2 button, in a small hole on the back of the controller.
  2. Using a paperclip, press and hold the reset button for a few seconds (7-12 seconds). This should be enough to reset the controller.

To reset the PlayStation 4 joystick:

  1. Turn off the PlayStation 4.
  2. Press and hold the reset button on the controller for 5 seconds to complete the process.
  3. Connect the controller to the console using a USB cable, turn on the PS4, and press the PlayStation button to start it.

To use a PS3 joystick on a PC with Windows 10, follow these steps:

  1. Choose the drivers to install and select "Install Dualshock 3 driver" for the PS3 controller or "Bluetooth Connection" for a Bluetooth connection.
  2. Then, select "Choose Controller" from the dropdown menu and select the desired controller from the list.
  3. Click "Next" to allow the installation of the drivers.

To connect a PS3 joystick:

  1. Turn on the PlayStation 3.
  2. Use the provided USB cable to connect the PS3 controller. Insert the smaller end into the controller and the opposite end into the USB port on the front of the PS3.
  3. The power of the PS3 will decrease. Once it stabilizes, you can disconnect the USB cable to use the controller in wireless mode.

Leave a Comment